Burner Accessories
Flame Stabilizer
This patented Humboldt unit fits 1/2" (13mm) diameter mixing tubes without modifications. It is recommended for use with gases of 800 BTU/cu.ft. or more and can be added to 1/2" (13mm) OD burner tubes to prevent the flame from blowing out.
Heat Intensifier Top
Designed to distribute the heat evenly across the top of high temperature burners through a perforated Monel plate. Same top as used on H-5500, H-5550 and H-5600.
Burner Grid Tops
Designed to diffuse the flame. Perforated monel grid, 1-1/4" diameter.
Flame Shield
Used to protect flame from drafts. The unit features of spring clips designed to fit 7/16" to 5/8" (11mm to 16mm) burner tubes. The cone is spot-welded and is 2" (51mm) in diameter at the bottom.
Burner Wing Tops
Designed to produce a broad, flat, fan-shaped flame. Ideally suited for use in bending glass tubing and other similar applications. Made of brass.
Gas Cylinder Clamp
Designed to safely and conveniently secure compressed gas cylinders in an upright position. Accommodates cylinders 4-1/2" to 11" (114mm to 279mm) in diameter. The heavy-duty clamp with adjustable thumbscrews fits conveniently on any bench up to 2" (51mm) thick without marring the surface.
Burner Gas Connector
Gas Connector. Flexible tube of rust-resistant steel covered with rubber and wrapped with braided cotton cloth. Slip-on ends for attachment to 9mm gas lines. Meets A.G.A.S. requirements. 3 ft. long. Other lengths available on special order.